Installing Blazer Flushmounts: Difference between revisions

(2 intermediate revisions by the same user not shown)

Line 12:

* A pair of Blazer brand truck marker lights

* Two bulbs, number 1156 - You can take them from the stock lights. [http://faq.ninja250.org/wiki/I_want_to_put_flush-mount_flashers_on_the_front#Bulbs Bulb #3497] should also work.

* Six bolts with nuts and washers (three per light base). Chances are that you have them already ~~laying~~ around your garage.

* Six bolts with nuts and washers (three per light base). Chances are that you have them already lying around your garage.

* Two nuts for the lens attachment (size unknown)

* Sabre saw or manual reciprocal saw

Line 20:

* Super glue

The marker lights come with very dim ~~and~~ small bulbs. Throw them away.

The marker lights come with very dim, small bulbs. Throw them away.

First, you need to modify the base in two steps:

Line 27:

* Cut the base so the bulb itself can slide through.

To cut the base use a sabre saw~~, a ,~~ or something similar. You should get something like this:

To cut the base, use a sabre saw or something similar. You should get something like this:

[[image:bl-05.jpg|150px]]

Line 67:

[[image:bl-08.jpg|150px]]

[[image:bl-02.jpg|150px]]

Put the lens in place, tighten the bolt, and wait until the glue is cured. Remove the lens, put the bulb in place, and attach the lens. You're done.

@@ Line 12: / Line 12: @@
 * A pair of Blazer brand truck marker lights
 * Two bulbs, number 1156 - You can take them from the stock lights. [http://faq.ninja250.org/wiki/I_want_to_put_flush-mount_flashers_on_the_front#Bulbs Bulb #3497] should also work.
-* Six bolts with nuts and washers (three per light base). Chances are that you have them already laying around your garage.
+* Six bolts with nuts and washers (three per light base). Chances are that you have them already lying around your garage.
 * Two nuts for the lens attachment (size unknown)
 * Sabre saw or manual reciprocal saw
@@ Line 20: / Line 20: @@
 * Super glue
-The marker lights come with very dim and small bulbs. Throw them away.
+The marker lights come with very dim, small bulbs. Throw them away.
 First, you need to modify the base in two steps:
@@ Line 27: / Line 27: @@
 * Cut the base so the bulb itself can slide through.
-To cut the base use a sabre saw, a , or something similar. You should get something like this:
+To cut the base, use a sabre saw or something similar. You should get something like this:
 [[image:bl-05.jpg|150px]]
@@ Line 67: / Line 67: @@
 [[image:bl-08.jpg|150px]]
+[[image:bl-02.jpg|150px]]
 Put the lens in place, tighten the bolt, and wait until the glue is cured. Remove the lens, put the bulb in place, and attach the lens. You're done.