How to build your own track bike: Difference between revisions
No edit summary |
No edit summary |
||
| Line 8: | Line 8: | ||
'''(Looks don't matter; function does)''' | '''(Looks don't matter; function does)''' | ||
*Low mileage w/ good-running engine | |||
*Ugly OK | |||
*Busted-up fairings OK | |||
*Dented exhaust OK | |||
*Broken bars OK | |||
*Broken turn signals and mirrors OK | |||
*Thrashed seat OK (should be repairable) | |||
*Dents in tank OK | |||
*Scratched paint OK | |||
*Broken headlight OK | |||
*Crashed is fine, but not crashed "hard" | |||
*Wheels perfect or nearly so | |||
*Frame / Forks not bent | |||
===To Do List=== | ===To Do List=== | ||
*Quality rear stand | |||
*[[Stainless steel brake lines upgrade.|SS brake lines]] (buy) (optional *) | |||
*[[I'd like to know more about clipons.|Woodcraft Lowered Risers]] | |||
*Woodcraft Rearsets (optional) | |||
*EBC HH or other quality [[What replacement pads should I consider?|front brake pads]] | |||
*Have head ported (optional *) | |||
*Drill oil filter and drain plug bolts & safety wire | |||
*[[Engine Oil|Oil and filter change]] (quality stuff) | |||
*[[How do I work on the carbs?|Clean or rebuild carbs]] | |||
*[[Exhaust|Ugly aftermarket exhaust]] (optional *) | |||
*Spend $ on dyno to verify jetting | |||
*[[Suspension|Quality rear shock]] | |||
*[[Suspension|Redo forks]] to race spec | |||
*[[What tire makes are available that fit the 250?|Install quality tires]] (Dunlop GT501) | |||
*Verify [[How do I adjust chain/rear wheel alignment?|wheel alignment]] and runout | |||
*[[How do I measure chain slack?|Proper chain tension]] and worthiness | |||
*Learn how to work with fiberglass and | |||
*[[Body plastics repair guide|repair fairings]] as needed (cosmetics no biggie) | |||
*Buy/make bellypan (optional *) | |||
*[[How do I raise the front fender to fit a 110-width tire?|Modify front fender]] | |||
*[[How do I service the cooling system?|Change out antifreeze]] to "water wetter" and water mix | |||
===Remove=== | ===Remove=== | ||
*Headlight assembly | |||
*Turn signals | |||
*Mirrors | |||
*Chain guard (optional *) | |||
*Rear fender assembly | |||
*Smog system if installed | |||
*Rear brake light assembly (optional *) | |||
*Speedometer cable (optional *) | |||
*Side and center stands | |||
===Inspect and Repair/Replace/Adjust as needed=== | ===Inspect and Repair/Replace/Adjust as needed=== | ||
*Steering head bearings | |||
*[[Replacing the wheel bearings|Wheel bearings]] | |||
*[[Final Drive|Chain & sprockets]] (stock gearing is fine) | |||
*Front fender | |||
*Radiator | |||
*Handlebars and grips | |||
*Control pods | |||
*All cables | |||
*[[Waterproofing your electrical connections|All electrical connections]] | |||
*Axles and hardware (washers, spacers and nuts) | |||
*Rear brake [[Brakes|pads and fluid]] | |||
*[[Suspension|Fork oil and dust seals]] | |||
*Chain tensioners | |||
*All nuts, screws and bolts | |||
===Minimal Bike Spares list=== | ===Minimal Bike Spares list=== | ||
*Front brake and clutch levers | |||
*Footpeg and bracket assemblies (optional *) | |||
*Spare handlebars (optional *) | |||
*Clutch and throttle cables (optional *) | |||
*One set spare spark plugs | |||
*Oil and filter | |||
*Electrical tape and 6 ft. of 12 gauge insulated wire | |||
*Duct tape (of course!) | |||
(optional *) items aren't really required, fractionally enhance bike performance, are too expensive, time consuming, or are not absolutely required for track days. | (optional *) items aren't really required, fractionally enhance bike performance, are too expensive, time consuming, or are not absolutely required for track days. | ||
'''NOTE''': Be aware that plenty of EX250 race bikes are sold each year, usually from October through March. You will likely get a better, cheaper, completely set up bike buying one of these than doing all this on your own. But then, what fun would that be? | '''NOTE''': Be aware that plenty of EX250 race bikes are sold each year, usually from October through March. You will likely get a better, cheaper, completely set up bike buying one of these than doing all this on your own. But then, what fun would that be? | ||