Installing Woodcraft lowered risers: Difference between revisions
No edit summary |
No edit summary |
||
| Line 41: | Line 41: | ||
A nice, neat hole. The drill bit that produced the hole closest in size to the stock bars was 7/32" (5.5mm). | A nice, neat hole. The drill bit that produced the hole closest in size to the stock bars was 7/32" (5.5mm). | ||
[[Image:Woodcraft risers 14.jpg]] | [[Image:Woodcraft risers 14.jpg|150px]] | ||
The choke assembly also has an anti-rotation pin. This one measured 50mm from the end of the bar to the center of the hole. A 7/32" bit worked for that one, too. Here are the bars just after being put on the bike, before mounting any controls. | The choke assembly also has an anti-rotation pin. This one measured 50mm from the end of the bar to the center of the hole. A 7/32" bit worked for that one, too. Here are the bars just after being put on the bike, before mounting any controls. | ||