Cleaning the carbs 1: Difference between revisions
| (One intermediate revision by the same user not shown) | |||
| Line 118: | Line 118: | ||
[[Image:Brian_Carb_Clean_12.JPG|150px]] | [[Image:Brian_Carb_Clean_12.JPG|150px]] | ||
When you take out the main jet, the emulsion tube (called 'holder' in the left picture) is behind it, | When you take out the main jet, the emulsion tube (called 'holder' in the left picture) is behind it, with the jet needle (also called 'collar') behind that. Be sure you get these little parts out (part #16017 on the diagram), as they could fall out on their own if you don't. | ||
[[image:Jim carb 2.jpg|150px]] | [[image:Jim carb 2.jpg|150px]] | ||
[[image:846663-2.jpg|70px]] | [[image:846663-2.jpg|70px]] | ||
[[image:CARBURETOR PARTS.png|50px]] | [[image:CARBURETOR PARTS.png|50px]] | ||
When you replace the collars, check in the carb intake to make sure they're poking through. They only go in one way. The longer, narrower end goes in first. | |||
For more views of all these parts, see [[Carburetor photos]]. | For more views of all these parts, see [[Carburetor photos]]. | ||