How to fine-tune your jetting: Difference between revisions
| Line 33: | Line 33: | ||
Shake the needle out, raise it with (however many) [[Washers for carb needles|2.5 or 3 mm washers]]. | Shake the needle out, raise it with (however many) [[Washers for carb needles|2.5 or 3 mm washers]]. | ||
If you're using aftermarket needles, start with the clip in the 3rd position (middle). This is usually for a stock or mildly modified setup, such as a slip-on exhaust. You can use washers to make "half" steps, too, for super-fine tuning. | *If you're using aftermarket needles, start with the clip in the 3rd position (middle). This is usually for a stock or mildly modified setup, such as a slip-on exhaust. You can use washers to make "half" steps, too, for super-fine tuning. | ||
Reassemble. | Reassemble. | ||