Installing AsianCycle flush-mounts: Difference between revisions
| Line 81: | Line 81: | ||
[[image:100_0953Before.jpg|150px]] | [[image:100_0953Before.jpg|150px]] | ||
Here | Here are external pictures of the finished alteration of the main fairing. If the fit is just a bit tight, use small sanding drums, your cutoff wheel, or a file to make it slightly bigger until you're satisfied with the fit. Yellow paper is used on the left to make the cutout area more visible. | ||
[[Image:IMG_0701.jpg|170px]] | [[Image:IMG_0701.jpg|170px]] | ||
[[image:100_0954HoleDrilled.jpg|150px]] | |||
Internal picture of the same. Notice that a small part of the inside of the circular section was taken out to allow for a proper fit. The flushmounts can be installed and removed without feeling that you're putting a strain on anything, but the fit is still nice and snug. | Internal picture of the same. Notice that a small part of the inside of the circular section was taken out to allow for a proper fit. The flushmounts can be installed and removed without feeling that you're putting a strain on anything, but the fit is still nice and snug. | ||