Difference between revisions of "Heated cold-weather gear"

Revision as of 01:42, 14 January 2011

Gerbing's

Gerbing's carries a complete line of heated gear for motorcyclists. They have everything from socks and pants to gloves and jackets, along with the controllers and accessories needed to make them work. They also have an outlet store. Quality and service are good.

Widder

Widder was a popular manufacturer of heated gear for a long time, but they are now officially history. Their website just says "Thanks for the memories." Widder products are now being sold through the Iron Butt Association eSTORE.

Mounting a plug for Widder gloves

The Widder gloves use a proprietary BMW connector, so you'll have to visit your local Bimmer Boutique to buy a plug. They're about $21. You can use the stock accessory connectors by cutting off the leads and soldering in some longer wires to go to the plug. Then, drill a hole in the side fairing to mount the plug. It comes with a nice looking weatherproof cap, so it looks good installed.

The plug is below thigh level, so the knee is further forward and there's no problem with the cord hitting the rider. The connector is waterproof, and the gloves work well.

Heated grips or gloves?

We try to keep opinion to a minimum here in the FAQ, but when it comes to comfort, it's always opinion. Here's the gloves vs. grips opinion of one experienced club member:

• I had a set of Widder gloves, but I just sold them on eBay. I now have Kimpex grip heaters on both of my bikes and am much happier. For me, the gloves are a big hassle; they're quite bulky, and connecting/disconnecting the wires every time you stop, plus dealing with the wires running through your jacket, are a big pain.

The grip heaters are always transparently there. They get quite warm; however, they obviously heat only the palms of your hands, but I find that works well enough for the convenience. They cost only about $30, and they aren't too difficult to install, though you should allow a couple of hours for a clean install with neat wiring.

Here is the copy from Kimpex on their grip heaters:

• Kimpex Grip Heater Kit

This kit is for placing heater strips under your grips and wiring into your bike. It has a three position switch for low, high and off.

To find these, go to your local dealer or run an online search. The Kimpex online catalog is nearly impossible to use.

Places to buy winter gear

One can always Google for what you want. Here are a couple places to start:

CozyWinters is a good place to look for winter clothing for motorcycling and other outdoor pursuits.

Forest City Surplus has discounted cold-weather gear.

Campmor is one of the most popular places for outdoor gear.

A word about the charging system

If you're looking to buy a complete set of heated gear, be aware that you probably won't be able to ride all day with everything turned on. Leon: "Vest alone - no problem. Vest, gloves and socks - I ran the battery completely dead once in about 5 hours while riding. Everything just got dim (and cool) and when I braked for a corner everything went completely dead. I was able to disconnect the gear and get the engine restarted by coasting down a hill."

"For rides of a couple of hours or less, there shouldn't be any issue with a normal set of electric gear. Just connect the battery tender when you get back home."

A voltmeter is a good tool to have if you're doing much riding with your heated clothing on.

Installing heated grips

See this page.